1. Poor heat dissipation of the ice maker
Solution: Open the ice machine cover to observe whether there is dust on the heat sink that affects the wind flow or other foreign objects block the heat sink, and it is enough to remove it.
Second, the ice machine does not have water
Solution: It must be that the water pump of the ice maker China Ice Makers Manufacturers
is broken. Just fix it. The water pump needs to be cleaned regularly for 2 months. If it is well protected, it will not be easy to break.
3. Ice time of ice making mechanism slows down
Solution: This is very simple. The refrigerant in the ice maker is gone, just add refrigerant.
4. The compressor works intermittently without making ice
Solution: The voltage is too low, check the power supply, the contact point is not burnt, and the system pressure protection is turned on.
Five, the ice machine wet ice borneol is not hard
Solution: The water supply of the ice maker water tray is too much and the refrigerant is added too much. The voltage is insufficient and the above phenomenon will occur. Add an appropriate amount of water and refrigeration system, turn off the voltage and adjust the voltage. This problem is relatively easy to solve.
Sixth, the ice machine is leaking
Solution: Do not supply too much water to the water pan from the inlet valve. The proper amount is required to see if the water pipe is broken. If the water pipe is broken, just replace it with a new one. See if the water level float valve is faulty, and if there is any fault, it is enough to debug and repair it.